From: Scott Morris (smorris@internetworkexpert.com)
Date: Sun Dec 21 2008 - 17:59:43 ARST
Let's start with the basics... Look at "show frame pvc | include ACTIVE" on
each router...
Scott
_____
From: Paul Adams [mailto:ccie.paul@gmail.com]
Sent: Sunday, December 21, 2008 12:01 PM
To: swm@emanon.com
Cc: Cisco certification
Subject: Re: FRAME-Relay - DLCI
Hello,
still no luck... its very simple from ur hint but nopes.
I enabled inverse arp and did debug no output......
Probably doing something very silly....
On Sun, Dec 21, 2008 at 5:31 PM, Scott Morris <swm@emanon.com> wrote:
You mean without the DLCI? Sure...
So, how does a router discover who's on the other end of any DLCI? How
about inverse arp.
Even if you "aren't allowed to have dynamic addressing", there's nothing
saying you can't turn it on and then turn it back off!
Think through of ALL the things that are available to you, and even things
you aren't "allowed" to do. Grading is done after the lab, not during. ;)
HTH,
Scott Morris, CCIE4 #4713, JNCIE-M #153, JNCIS-ER, CISSP, et al.
CCSI/JNCI-M/JNCI-ER
Senior CCIE Instructor
smorris@internetworkexpert.com
Knowledge is power.
Power corrupts.
Study hard and be Eeeeviiiil......
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Paul
Adams
Sent: Sunday, December 21, 2008 8:51 AM
To: Cisco certification
Subject: FRAME-Relay - DLCI
Hi,
Is it a possibility to get a question on frame-relay with providing the DLCI
information in it.
If so how to identify the DLCI to be used in this scenario.
Example :
R1 is connected to R5
R1 = int fa 0/0.15 ( ip address : 10.10.1.1 /24)
R5 = int fa 0/0.15 ( ip address : 10.10.1.5 /24)
Thanks
Blogs and organic groups at http://www.ccie.net <http://www.ccie.net/>
This archive was generated by hypermail 2.1.4 : Thu Jan 01 2009 - 12:53:09 ARST