From: Bit Gossip (bit.gossip@chello.nl)
Date: Wed Nov 05 2008 - 19:59:33 ARST
Expert,
I was trying to configure a static LSP with manual labe binding and
swapping, just as a learning exercise, no special use of it.
On a P device I want it to swap input label 1001 with output label 1002
but this is what I get. Please not that according to:
http://www.cisco.com/en/US/docs/ios/mpls/configuration/guide/mp_vrf_aware_static.html
it should work.
Any alternative for a static LSP?
Thanks,
bit
p1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
p1(config)#mpls label range 16 1000 static 1001 1099
p1(config)#mpls static crossconnect 1001 Serial1/0 192.168.0.2 1002
% This command is an unreleased and unsupported feature
p1(config)#
*Nov 5 22:55:20.611: %LSD-4-BADAPI: illegal QoS value 0 from STATIC
p1(config)#
p1(config)#do show run | i mpls
mpls static
mpls label range 16 1000 static 1001 1099
mpls static labelswitch 1001 qos uninitialized
p1(config)#do br | ex una
Interface IP-Address OK? Method Status
Protocol
Serial1/0 192.168.0.2 YES NVRAM up
up
Serial1/1 192.168.0.1 YES NVRAM up
up
Loopback0 192.168.255.11 YES manual up
up
p1(config)#do show ver
Cisco IOS Software, 7200 Software (C7200-ADVIPSERVICESK9-M), Version
12.4(20)T, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2008 by Cisco Systems, Inc.
Compiled Fri 11-Jul-08 04:22 by prod_rel_team
ROM: ROMMON Emulation Microcode
BOOTLDR: 7200 Software (C7200-ADVIPSERVICESK9-M), Version 12.4(20)T,
RELEASE SOFTWARE (fc3)
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Dec 01 2008 - 08:18:29 ARST