From: Anthony J Sequeira (asequeira@internetworkexpert.com)
Date: Fri Oct 24 2008 - 14:37:27 ARST
Careful here - there is no such thing as mac-address sticky "mac of R2".
Here is how sticky learning works. You configure the MAC address to be
sticky learned using the mac-address sticky syntax. The MAC is then
dynamically learned and written as a static entry to the RUNNING CONFIG. In
order to survive reboots, you then need to write the RUNNING CONFIG to the
STARTUP CONFIG. Once you do that - you are good to go. :-)
Warmest regards,
Anthony J. Sequeira, CCIE #15626, CCSI #23251
Senior CCIE Instructor
asequeira@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Outside US: 775-826-4344
On 10/24/08 12:29 PM, "nouman abbasi" <abbasi.nouman@gmail.com> wrote:
> Hello,
>
>
> R2 & R5 are connected to SW1 on ports fa 0/2 & fa 0/5 Secure the Switch
> ports by allowing mac address of these routers
> Log violation to policy and allow permited traffic to flow, make
> sure configuration survives on reboot
>
>
> based on the question ; will the solution be correct with "mac-address
> sticky" statement or mac-address sticky "mac of R2" statement.
>
>
> wht step is rquired for the configuration to survives on reboot??
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sat Nov 01 2008 - 15:35:22 ARST