From: Roger RPF (rpf@bluemail.ch)
Date: Tue Oct 14 2008 - 05:35:38 ART
Yes, you have to, because you only say to redistribute RIP into EIGRP but
this Loopback is a connected interface.
So then, if you do also a redistribute connected into eigrp and specify a
route map, you would also have to add the eth0/0 RIP interface into the
route-map, because this is also a connected interface.
Lab it up, you will see
regards
Roger
-----Urspr|ngliche Nachricht-----
Von: nobody@groupstudy.com [mailto:nobody@groupstudy.com] Im Auftrag von
Reza Toghraee
Gesendet: Dienstag, 14. Oktober 2008 10:21
An: 'Cisco certification'
Betreff: Simple Redistribution Question
Hello
R1 has 2 Ethernet InterfacesE0/0 and E0/1 and a LoopBack 0
R1 is running RIP on E0/0
R1 is running EIGRP on E0/1
Task is asking to advertise Loopback into the RIP without "network" command.
So we do redistribution with a route-map to match the loopback interface.
Next
Task is asking redistribute RIP into EIGRP.
For this task I use "redistribute rip metric 1 1 1 1 1"
the router performs a "show ip route rip" and finds the RIP routes and
redistributes them into EIGRP
the router finds the interfaces which are running RIP (in this case
E0/0), and redistributes it into EIGRP
now Do we need to manually redistribute the Loopback interface which is
already redistributed into RIP in previous question, into the EIGRP?
Thanks
Reza
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sat Nov 01 2008 - 15:35:20 ARST