From: Victor Cappuccio (vcappuccio@gmail.com)
Date: Sat Sep 20 2008 - 05:45:58 ART
That would be great to do as well, but I think that you can just tune is the
time of the load interval
Router(config)#int s0/0
Router(config-if)#load-interval ?
<30-600> Load interval delay in seconds
I always try to change those values in real production network, because you
can now in 30 sec how much bps is crossing over that interface in particular
but anyways, The notation you see at the show policy-map or the output rate
from the show interface is based on my opinion in the SI prefixes for
decimal multiples http://members.optus.net/alexey/prefSI.xhtml, now you can
just in your mind divide by 1000 and you get the kbits/sec you are asking
for.
My 2 Cents
Victor.-
On Fri, Sep 19, 2008 at 5:42 PM, vignesh sethuraman <
sethuvignesh@yahoo.co.in> wrote:
> Hello Experts,
>
> I have a question regarding the 5 minute input/output rate.
>
> In the output of show interface <int number>, we will be seeing 5 minute
> input rate/output rate in bits/sec. Is it possible to make the device show
> it
> in kbits/sec.
>
> Thanks,
> Vignesh
>
>
>
> Connect with friends all over the world. Get Yahoo! India Messenger
> at http://in.messenger.yahoo.com/?wm=n/
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>
-- Victor Cappuccio CCIE R/S# 20657 CCSI# 30452 www.anetworkerblog.comBlogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sat Oct 04 2008 - 09:26:19 ART