From: David Prall (dcp@dcptech.com)
Date: Thu Sep 18 2008 - 17:19:32 ART
I've always done it on both ends. What good is it if it isn't configured on
both ends.
-- http://dcp.dcptech.com> -----Original Message----- > From: Ivan Walker [mailto:ivan@itpro.co.nz] > Sent: Thursday, September 18, 2008 3:58 PM > To: David Prall > Cc: 'ccie'; ccielab@groupstudy.com > Subject: Re: keep alive on the tunnel interface > > According to > http://www.cisco.com/en/US/tech/tk827/tk369/technologies_tech_ > note09186a008040a17c.shtml > -> "The tunnel keepalive mechanism functions even if the far tunnel > endpoint does not support keepalives." that is not correct. > > David Prall wrote: > > Yes, must be configured on both ends. The tunnel keepalive > command requires > > timers. > > > > David > > > > -- > > http://dcp.dcptech.com > > > > > > > >> -----Original Message----- > >> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On > >> Behalf Of ccie > >> Sent: Thursday, September 18, 2008 3:11 PM > >> To: ccielab@groupstudy.com > >> Subject: keep alive on the tunnel interface > >> > >> Hi expert, > >> > >> If I have tunneling interface between two routers, does the > >> keep alive on > >> this interface send a periodic keep alive from the tunnel > >> source to the > >> tunnel destination. E.g. does the up of the tunnel interface > >> mean that there > >> is a reach ability between the tunnel source and the tunnel > >> destination. > >> > >> Regards, > >> > >> Amin > >> > >> > >> Blogs and organic groups at http://www.ccie.net > >> > >> ______________________________________________________________ > >> _________ > >> Subscription information may be found at: > >> http://www.groupstudy.com/list/CCIELab.html > >> > > > > > > Blogs and organic groups at http://www.ccie.net > > > > > ______________________________________________________________ > _________ > > Subscription information may be found at: > > http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sat Oct 04 2008 - 09:26:18 ART