From: Ivan Walker (ivan@itpro.co.nz)
Date: Thu Sep 18 2008 - 16:57:32 ART
According to
http://www.cisco.com/en/US/tech/tk827/tk369/technologies_tech_note09186a008040a17c.shtml
-> "The tunnel keepalive mechanism functions even if the far tunnel
endpoint does not support keepalives." that is not correct.
David Prall wrote:
> Yes, must be configured on both ends. The tunnel keepalive command requires
> timers.
>
> David
>
> --
> http://dcp.dcptech.com
>
>
>
>> -----Original Message-----
>> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
>> Behalf Of ccie
>> Sent: Thursday, September 18, 2008 3:11 PM
>> To: ccielab@groupstudy.com
>> Subject: keep alive on the tunnel interface
>>
>> Hi expert,
>>
>> If I have tunneling interface between two routers, does the
>> keep alive on
>> this interface send a periodic keep alive from the tunnel
>> source to the
>> tunnel destination. E.g. does the up of the tunnel interface
>> mean that there
>> is a reach ability between the tunnel source and the tunnel
>> destination.
>>
>> Regards,
>>
>> Amin
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> ______________________________________________________________
>> _________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>>
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sat Oct 04 2008 - 09:26:18 ART