Re: Minimum VLAN Configuration

From: Ali Mousawi (mousawi.ali@gmail.com)
Date: Tue Sep 16 2008 - 15:59:59 ART


Hi Igor,

One trick i follow is drawing the switches with the physical connections and
trunks. Then run over the Diagram and writing vlans numbers. Then check for
transit Vlans. Lets say SW1 ----> SW2 ------> SW3 then if we
have vlan100 in sw1 and sw3 and the only route between those 2 switches is
through sw2 then you should add vlan100 to sw2.

HTH

On Tue, Sep 16, 2008 at 10:38 AM, Igor M. <imanassypov@rogers.com> wrote:

> I normally go through L2/L3 diagrams in the IE and I do the minimum that I
> see required at the moment. Along the way I do the lab, and if I realize
> that one is missing - just go ahead and add it. That way, incrementally, but
> you still keep it to a minimum...
>
> ----------------------
>
> I.M., M.Eng. P.Eng.
>
> Network Architect
>
> CI Investments
>
> ----------------------
>
> --- On Tue, 9/16/08, Atlanta CCIE <atlantaccie@gmail.com> wrote:
> From: Atlanta CCIE <atlantaccie@gmail.com>
> Subject: Minimum VLAN Configuration
> To: "Cisco certification" <ccielab@groupstudy.com>
> Received: Tuesday, September 16, 2008, 1:30 PM
>
> I am not sure about others but I have hard time trying to figure out the
> minimum numbers of VLANs needed by looking at the diagram. What method do
> you guys use to come up with this? I tried looking at the topology diagrams
> but I always leave some vlans out that are not on the diagram but in the
> IE's SG. Any help would be highly appreciated :D
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net



This archive was generated by hypermail 2.1.4 : Sat Oct 04 2008 - 09:26:18 ART