Re: How do I simulate Up/down condition on a serial interface?

From: Lala Lander (sshafi@gmail.com)
Date: Sat Aug 16 2008 - 19:38:59 ART

• Next message: Hobbs: "volume 1 section 13.2 - denying tacacs"
• Previous message: Lala Lander: "How does set ip next-hop suppose to behave?"
• Maybe in reply to: Lala Lander: "How do I simulate Up/down condition on a serial interface?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

thanks so much... encap ppp did the trick for me

On Sat, Aug 16, 2008 at 3:14 PM, Lloyd Ardoin <Lloyd@thewizkid.biz> wrote:

> You could apply frame-relay end-to-end keepalives only on one side with
> either bidirectional or request mode and that will simulate a down
> connection.
>
> Lloyd V Ardoin
>
> Network Engineer
>
> CCDA, CCNP, CCSP, GSEC, GCFW, CISSP
>
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Lala Lander
> Sent: Saturday, August 16, 2008 4:55 AM
> To: Cisco certification
> Subject: How do I simulate Up/down condition on a serial interface?
>
> thanks in advance Gurus!
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net

• Next message: Hobbs: "volume 1 section 13.2 - denying tacacs"
• Previous message: Lala Lander: "How does set ip next-hop suppose to behave?"
• Maybe in reply to: Lala Lander: "How do I simulate Up/down condition on a serial interface?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Sep 01 2008 - 08:15:31 ART