From: Hobbs (deadheadblues@gmail.com)
Date: Sun Aug 10 2008 - 19:20:56 ART
you don't need to telnet again to SW1. just resume your connection by typing
1 and then enter.
"show sessions" will show you the session numbers in the term server.
On Sun, Aug 10, 2008 at 4:13 PM, jjrinehart@hotmail.com <
jjrinehart@hotmail.com> wrote:
> Telnet into the TS by IP and port that corresponds to the correct line,
> e.g., 2001 for line 1, 2002 for line 2, etc.
>
> Joe
>
> -----Original Message-----
> From: "Raghav Bhargava" <raghavbhargava12@gmail.com>
> To: "Cisco certification" <ccielab@groupstudy.com>
> Sent: 8/10/08 1:12 PM
> Subject: Terminal Server Config
>
> Hi Experts,
>
> I have a Terminal Server configured and connected to my Lab devices. I
> can telnet into them but the only problem is for Example I telnet into
> SW1 and go to Terminal Server and then telnet into SW2. Now when I
> want to go back to SW1 , I go back to Terminal Server and I have the
> clear the line for SW1 and then it allows me to telnet SW1 again
> otherwise it says connection refused..
>
> I dont want to open separate windows but just use the same window and
> switch between devices.
>
> I know th
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Sep 01 2008 - 08:15:30 ART