From: Khawar Butt (khawarb@khawarb.com)
Date: Sun Aug 10 2008 - 01:21:26 ART
Hi Johnny,
It is probably their Frame Relay Switch. Do a "Show Frame-relay LMI" to see
if you are sending and receiving LMI. If not, tell them to check their Frame
Switch configurations and status.
Khawar Butt
CCIE#12353 (R/S , Security , SP , Voice)
http://www.khawarb.com
http://www.netmetric-solutions.com
E-mail : khawarb@khawarb.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Jonny English
Sent: Sunday, August 10, 2008 9:31 AM
To: GS CCIE-Lab
Subject: Please help
Hi, I'm having a hard time trying to see the problem here. I don't think
there is one, but I'm doing a lab on a rack rental and this is what's
happening
Rack1R1#sh ip int brief
Interface IP-Address OK? Method Status
Protocol
FastEthernet0/0 unassigned YES unset administratively down
down
Serial0/0 191.1.125.1 YES manual up
down
Serial0/1 unassigned YES unset administratively down
down
the serial int s0/0 is always up down. My config of the routers is below.
All three routers R1, R2 and R5 should be connected to the frame-switch. But
for some reason on R1 the s0/0 protocol on the interface keeps flapping. The
rack rental company said it was a layer 3 issue with my config. I stripped
the config of and reloaded the routers. Then just did the frame stuff again.
I have the same problem with R1's s0/0 interface keeps flapping. Does anyone
have any ideas on what could be wrong here? I can't for the life of me see
what is wrong with my configs. Thanks in advance.
Rack1R1#sh run int s0/0
Building configuration...
Current configuration : 243 bytes
!
interface Serial0/0
ip address 191.1.125.1 255.255.255.0
encapsulation frame-relay
no dce-terminal-timing-enable
frame-relay map ip 191.1.125.5 105 broadcast
frame-relay map ip 191.1.125.2 102 broadcast
no frame-relay inverse-arp
end
--Rack1R2#sh run int s0/0 Building configuration...
Current configuration : 253 bytes ! interface Serial0/0 ip address 191.1.125.2 255.255.255.0 encapsulation frame-relay no dce-terminal-timing-enable frame-relay map ip 191.1.125.5 201 frame-relay map ip 191.1.125.1 201 broadcast no frame-relay inverse-arp
--
Rack1R5#$ sh run int s0/0
Building configuration...
Current configuration : 281 bytes ! interface Serial0/0 ip address 191.1.125.5 255.255.255.0 encapsulation frame-relay no dce-terminal-timing-enable frame-relay map ip 191.1.125.1 501 broadcast frame-relay map ip 191.1.125.2 501 no frame-relay inverse-arp frame-relay lmi-type cisco end
-- Thank You,
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Sep 01 2008 - 08:15:29 ART