From: Scott Morris (smorris@internetworkexpert.com)
Date: Sun Jul 20 2008 - 15:22:42 ART
You CAN configure it on both sides if it makes you feel better. But like
Jason pointed out, it's not necessary to do so.
HTH,
Scott Morris, CCIE4 #4713, JNCIE-M #153, JNCIS-ER, CISSP, et al.
CCSI/JNCI-M/JNCI-ER
Senior CCIE Instructor
smorris@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Outside US: 775-826-4344
Online Community: http://www.IEOC.com
CCIE Blog: http://blog.internetworkexpert.com
Knowledge is power.
Power corrupts.
Study hard and be Eeeeviiiil......
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Jason Madsen
Sent: Sunday, July 20, 2008 1:51 PM
To: Carlson guo
Cc: ccielab@groupstudy.com
Subject: Re: about ospf mtu-ignore
the ignore statement is required when a device has a lower MTU value than
that being received.
On Sun, Jul 20, 2008 at 10:36 AM, Carlson guo <carlson.guo@gmail.com> wrote:
> hi, guys,
>
> I have one Router R1 and a switch S1, they connected with fast
> ethernet interfaces, R1 interface Mtu is 1500, S1 system MTU is 1504,
> they are running OSPF in between, to let them work, I configued: "ip
> ospf mtu-ignore"
> on R1 fa0/0, and ospf works perfectly, my question is, why we don't
> have to configure the same command on S1?
>
>
> ______________________________________________________________________
> _ Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon Aug 04 2008 - 06:11:56 ART