From: GAURAV MADAN (gauravmadan1177@gmail.com)
Date: Sun Jul 20 2008 - 03:25:23 ART
One thing to remember is that SVI will come in UP state depending on
whether the corresponding vlan is present in vlan database or not .
Assosiating the port to vlan does not come in picture .
Hope it helps
Gaurav Madan.
On Sun, Jul 20, 2008 at 11:49 AM, Anthony Sequeira
<Anthony_Sequeira@skillsoft.com> wrote:
> Hi David!
>
> Here we create an SVI and assign an IP address:
>
> interface vlan 10
> ip address 172.16.1.10 255.255.255.0
>
> Here the SVI becomes active:
>
> interface fa0/9
> switchport mode access
> switchport access vlan 10
> no shutdown
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> David Cruz
> Sent: Saturday, July 19, 2008 1:28 PM
> To: ccielab@groupstudy.com
> Subject: Switch Virtual Interface (SVI)
>
> Hello Everyone,
>
> In the "Catalyst 3750 Switch Software Configuration Guide, Rel.
> 12.1(19)EA1"
> it states the following:
>
> "When you create an SVI, it does not become active until it is
> associated
> with a physical port."
>
> Does this association happen dynamically? Is there a command that has to
> be
> input? Any claification will be greatly appreciated.
>
> Regards,
>
> David
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
> No virus found in this incoming message.
> Checked by AVG - http://www.avg.com
> Version: 8.0.138 / Virus Database: 270.5.2/1562 - Release Date:
> 7/19/2008 2:01 PM
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon Aug 04 2008 - 06:11:55 ART