From: Phil Priest (ppriest@comms-care.com)
Date: Thu Jul 17 2008 - 12:31:41 ART
I had the same issue when i was setting it up. I seem to remember that
if you just continue and ignore the message it still works!
Alternatively you can just copy the package via TFTP I believe..
Also, make sure the pool of addresses you assign to clients is either in
the same subnet as you internal LAN address or create a loopback for the
new subnet or it will not work...
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
omar parihuana
Sent: 17 July 2008 16:06
To: Cisco certification
Subject: SSLVPN Cannot install package
Hi List,
I'm setting a simple SSL VPN concentrator on a 2801 and I would like to
use
full-tunnel-mode, but unfortunately I cannot install the Cisco SSL VPN
Client Software (I'm using SDM for configure SSL ) when try to intall I
get
the follow error:
Error installing package: Unknow Error
This may occur if your router use LEFS file system. Converting it to use
DOS
file system may resolve this issue.
then the question is: if the problem is file system from my CompactFlash
how
can I convert to file system from LEFS to DOS File system? or anyway how
can
I use full-tunnel using a Cisco 2801.
Clientless tunnel is working well.
Rgds.
-- Omar E.P.T ----------------- Certified Networking Professionals make better Connections!
This archive was generated by hypermail 2.1.4 : Mon Aug 04 2008 - 06:11:55 ART