From: Greg Martin (justler@krweb.net)
Date: Sat Jul 12 2008 - 07:29:03 ART
Hey Guys,
I've got an IAD 2431 2xT1/E1 router.
I'm trying to configure the T1 ports but after I enable the card, I go into
the T1 controller and do a channel-group 0 timeslots 1-24 speed 64 and I get
this message:
%LINK-6-BERTMSGS: Configuration not accepted, BERT is running
Google'd it and came back with nothing.
Running 12.4.18 IP Plus/FW/VOICE
Config:
card type t1 1
!
controller t1 1/0
framing esf
linecode b8zs
channel-group 0 timeslots 1-24 speed 64
Then it prints:
%LINK-6-BERTMSGS: Configuration not accepted, BERT is running
It prints this message when I try to modify any commands on the controller.
I've tried plugging in a loop plug so the bert tests could finish, but no
dice.
Can anyone point me in the right direction? I've search over cisco.com and
i've configured hundreds of wic-1dsu-t1/e1/g703 dsu modules and have never
run into this...
Regards,
Greg
This archive was generated by hypermail 2.1.4 : Mon Aug 04 2008 - 06:11:54 ART