Etherchannel...

From: seyfert . (seyfert22@googlemail.com)
Date: Thu Jul 03 2008 - 13:00:16 ART

• Next message: Dale Shaw: "Re: T1 speed"
• Previous message: Marc La Porte: "Re: T1 speed"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Dear Master,

If I was a question like this
"User in vlan xx has been complaining about slow response,
after further investigation, NOC has discovered that trunk between SW1 and
SW2
has been overloaded,
Configure SW1 and SW2 to have a link of 300Mbit/s and use that link
efficiently
and make sure fault tolerance
"

Vlanxx -----SW1(3560)=======SW2(3560)

Does it mean etherchannel with load balance?

SW1
Port-channel load-balance src-mac or
Port-channel load-balance src-ip

SW2
port-channell load-balance dst-mac or dst-ip

Hmm..btw, Is there any fault tolerance in etherchannel.
Just like in tunnel , there is "tunnel checksum" ==>to check/verify the
packet in the tunnel

Thanks,

Yhs

• Next message: Dale Shaw: "Re: T1 speed"
• Previous message: Marc La Porte: "Re: T1 speed"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Aug 04 2008 - 06:11:53 ART