RIP protocol is not visible in sh run

From: want2bccie . (want2bccie@gmail.com)
Date: Fri Jun 13 2008 - 08:27:48 ART

• Next message: Paul Cosgrove: "Re: CCIE on Trial at NetworkWorld"
• Previous message: Győri Gábor: "Qos pre-classify"
• Next in thread: Muhammad Nasim: "Re: RIP protocol is not visible in sh run"
• Maybe reply: Muhammad Nasim: "Re: RIP protocol is not visible in sh run"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi All,

I have some strange problem with RIP, whenever i'm running rip on my router
its not showing up in sh run output.

topology:
BB(RIP)<---->(RIP)R1(RIP)<---->(RIP)R2

Config on R1 :
router rip
ver 2
no auto-summary
passive-interface default
nei 150.x.19.254 (BB's ip add)
nei x.x.12.2 (R2's ip add)
net 150.x.0.0
net x.0.0.0

but if I run BGP or OSPF it can be seen.

Regards,

• Next message: Paul Cosgrove: "Re: CCIE on Trial at NetworkWorld"
• Previous message: Győri Gábor: "Qos pre-classify"
• Next in thread: Muhammad Nasim: "Re: RIP protocol is not visible in sh run"
• Maybe reply: Muhammad Nasim: "Re: RIP protocol is not visible in sh run"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Jul 01 2008 - 06:23:21 ART