From: Chris Gray (chris.gray@ozonenetworks.net)
Date: Wed Jun 11 2008 - 03:09:09 ART
Hi,
I am referring to the following option:
SW2(config-if-range)#channel-group 1 mode
active Enable LACP unconditionally
auto Enable PAgP only if a PAgP device is detected
desirable Enable PAgP unconditionally
>> on Enable Etherchannel only <<
passive Enable LACP only if a LACP device is detected
I think the general consensus is that it is not an IEEE protocol in itself.
regards
-----Original Message-----
From: Joe Gagznos [mailto:kemphall@yahoo.com]
Sent: 10 June 2008 22:05
To: Chris Gray
Cc: ccielab@groupstudy.com
Subject: Re: Etherchannel mode ON
I think you might be getting things confused. There are two ways to
channeling protocols - PAGP and LACP. PAGP is Cisco proprietary where LACP
is a IEEE standard. Both channeling protocols have an "on" mode. Now if
you asked about active or passive mode - only LACP offers those modes (and
thus are approved for use by the IEEE).
--- On Tue, 6/10/08, Chris Gray <chris.gray@ozonenetworks.net> wrote:
> From: Chris Gray <chris.gray@ozonenetworks.net>
> Subject: Etherchannel mode ON
> To: ccielab@groupstudy.com
> Date: Tuesday, June 10, 2008, 1:57 AM
> Hi group,
>
> A quick Question.
>
> Is Etherchannel mode 'on' an IEEE standard or
> proprietary?
>
> Anyone know?
>
> Chris
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jul 01 2008 - 06:23:21 ART