From: Peter Svidler (doubleccie@yahoo.com)
Date: Wed Jun 04 2008 - 09:57:16 ART
that is exactly what i was expecting ..however i got an error message says that MDT is using interface x for IP address x.x.x.x which is non-loopback interface.
the BGP is using the loopback in both IPV4 and VPNv4 , and PIM is enabled on the loopback
I have seen similar post to similar problem in the archieve ..however have not seen any answer to it
--- On Wed, 6/4/08, dara tomar <wish2ie@gmail.com> wrote:
From: dara tomar <wish2ie@gmail.com>
Subject: Re: Multicast VPN with MDT
To: "Peter Svidler" <doubleccie@yahoo.com>
Date: Wednesday, June 4, 2008, 8:39 AM
Hi Peter,
It should use the same loopback address as the BGP with PIM enabled on it!!!
What's the issue, that you are facing, can you elaborate please !!!
Regards,
Dara
On Wed, Jun 4, 2008 at 5:00 PM, Peter Svidler <doubleccie@yahoo.com> wrote:
Folks
I have a scenario where I am trying to build Multicast VPN using MDT between PE's .
one of my routers , strangely , is not using the loopback address to initiate the tunnel (using MDT as explained in documentation should usually use the BGP peer address , which in my case is the loopback to intiate the tunnel )
I wonder if anyone came across similar problem and explain why it happens?
thanks
This archive was generated by hypermail 2.1.4 : Tue Jul 01 2008 - 06:23:20 ART