From: Dale Kling (dalek77@gmail.com)
Date: Wed May 28 2008 - 20:42:28 ART
Ok so I deleted the BVIs, took the bridge groups off the serial interfaces.
Reconfigured the BVI first this time and then applied the bridge groups to
the interface and it works now. Did I miss some where that you have to
configure the BVIs first before you apply the bridge groups or am I losing
my mind. I believe I already am losing my mind, so you won't hurt my
feelings if you say so!
Dale
On Wed, May 28, 2008 at 7:32 PM, Dale Kling <dalek77@gmail.com> wrote:
> Is there because I swear I configure it right the first time and half the
> time I can't ping BVIs across the damn serial links. I have to reconfigure
> it again or 3 times and it magically starts working. WTF over?
>
> regards,
>
> Dale
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:18 ART