From: Michel Grossenbacher (pashtuk@gmail.com)
Date: Mon May 26 2008 - 07:56:46 ART
Hi Kriz
As far as I can remember, if you do IPv6 with the switches, you have to
choose the dual-ipv4-ipv6 template. Otherwise you cant use IPv6 with them.
I guess if you have to change the sdm within a task they will describe what
they need. If they do not write something about the template, do not change
it :-)
hope it helps
best regards
Michel
On 26/05/2008, Chris Gray <chris.gray@ozonenetworks.net> wrote:
>
> Any one offer guidance on which 3550 / 3560 SDM template we should use in a
> typical LAB where we have multicast, routing, Q in Q, IPV6 and all the
> features we usually end up with?
>
>
>
> SW1(config)#sdm prefer ?
> access Access bias
> default Default bias
> dual-ipv4-and-ipv6 Support both IPv4 and IPv6
> routing Unicast bias
> vlan VLAN bias
>
>
> Kriz
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:18 ART