From: Jack Flash (jack.flash@inbox.com)
Date: Sat May 24 2008 - 16:10:26 ART
You need to use the built in ethernet switch...
http://dynagen.org/tutorial.htm#_Toc193248002
Essentially it's this...
---------------------
[[ETHSW S1]]
1 = access 1
2 = access 20
3 = dot1q 1
#4 = dot1q 1 NIO_gen_eth:eth0
4 = dot1q 1 NIO_gen_eth:\Device\NPF_{B00A38DD-F10B-43B4-99F4-B4A078484487}
Port 1 of the switch (connected to R1 F1/0) is an access port in VLAN 1.
Port 2 is also an access port, but in vlan 20. Port 3 is a trunk port
(specified with the dot1q keyword) with a native VLAN of 1. Trunk ports
trunk all the VLANs known to the switch.
--------------------
Regards,
-----Original Message-----
From: shady darwish [mailto:engshad.shady@gmail.com]
Sent: 24 May 2008 19:48
To: Jack Flash
Subject: Re: need to connect dynamips to real switches
how
On Sat, May 24, 2008 at 10:32 PM, Jack Flash <jack.flash@inbox.com> wrote:
> Also, it's possible to trunk all your connections to 1 switch, eg an old
> 2950, then break them out from there to each of your real switches.
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> shady darwish
> Sent: 24 May 2008 17:47
> To: Cisco certification
> Subject: need to connect dynamips to real switches
>
> what hardware do i need to connect real switches to dynamips what brand is
> good
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG.
> Version: 7.5.524 / Virus Database: 269.24.1/1463 - Release Date:
23/05/2008
> 15:36
>
>
>
-- No virus found in this incoming message. Checked by AVG. Version: 7.5.524 / Virus Database: 269.24.1/1463 - Release Date: 23/05/2008 15:36
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:18 ART