From: Jack Flash (jack.flash@inbox.com)
Date: Sat May 24 2008 - 12:02:23 ART
Peter,
I can't find any command to override this behavior either.
You could always use the following instead of your default, but I guess
that's not what you're after.
Ip route 0.0.0.0 128.0.0.0 x.y.z.a
Ip route 128.0.0.0 128.0.0.0 x.y.z.a
Regards,
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Peter Svidler
Sent: 24 May 2008 12:29
To: ccielab@groupstudy.com; security@groupstudy.com
Subject: BGP peering based on default route
Folks,
I am trying to peer between two IBGP neighbors using the loopback address
for peering , since the loopbacks are not known specifically to each peer (
only default route is available ) ..im not able to get the session up .. i
know this is normal behavior for BGP that it will not peer if the peer
address is not exciplictly known ..i wonder if there is any way to override
this behavior ?
thanks in advance
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:18 ART