From: Muhammad Nasim (muhammad.nasim@gmail.com)
Date: Tue May 13 2008 - 23:08:18 ART
Or you can use "both" option to monitor the traffic both ways
HTH
2008/5/14 Matt Bentley <mattdbentley@gmail.com>:
> Hello:
>
> It would be TX - the rx/tx refers to what direction traffic is traversing
> the interface. If it is traffic coming INTO the interface, it would be
> RX.
> If traffic LEAVING the interface, it would be TX.
>
> HTH
>
> On Tue, May 13, 2008 at 8:43 PM, Athaide, Dwayne <DAthaide@epco.com>
> wrote:
>
> > If I was to monitor all traffic coming "from" port f0/1 on Sw1. Would
> > that
> > be rx in my monitor session or "tx"
> >
> > Monitor session 1 source int f0/1 "rx/tx"
> >
> > Thanks
> >
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
-- Muhammad Nasim Network Engineer Saudi Arabia
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:16 ART