RE: OSPF Question for connecting to Area 0

From: Shine (shinepjoseph@iprimus.com.au)
Date: Sat May 10 2008 - 05:43:03 ART

• Next message: itsfortarget iwillgetit: "Re: HSRP"
• Previous message: Narbik Kocharians: "Re: how to reply post"
• Maybe in reply to: dave dave: "OSPF Question for connecting to Area 0"
• Next in thread: dave dave: "Re: OSPF Question for connecting to Area 0"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I think the answer is Virtual link between R1&R2, R2&R3, R3&R4, R4&R5 and
R6&R7.

Regards,
Shine

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of dave
dave
Sent: Saturday, 10 May 2008 4:42 PM
To: Cisco certification
Subject: OSPF Question for connecting to Area 0

Hi Expert,

  I dont have any area as a stub area then how will i connect the all area
to area0 & how will able to see the lookback addres in area100 on router R7.
Can it possible with out using GRE tunnel?

* loopback in area 100<==* R1 <--Area10---> R2 <--Area20 --->R3
<---Area30---->R4<---Area40---->R5<-- *Area0 *--->R6 <---Area50---->R7

Regards,
Mukesh

• Next message: itsfortarget iwillgetit: "Re: HSRP"
• Previous message: Narbik Kocharians: "Re: how to reply post"
• Maybe in reply to: dave dave: "OSPF Question for connecting to Area 0"
• Next in thread: dave dave: "Re: OSPF Question for connecting to Area 0"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:16 ART