From: V.Shekhar@GlobalAssurance.Net
Date: Fri May 09 2008 - 14:40:37 ART
Also Please check for any SPAN monitor sessions, and VLAN access maps
which are not visible under the interface config.
---V Shekhar CCIE(sec)#17589/CISSP/RHCE.
Jason Madsen wrote: > I would do a "show run interface xx" and see if your interfaces are > configured the same. If I remember correctly, if your interfaces (ether > channel members) are individually configured as trunks, they need to have > the same VLANs allowed on each of them...I believe your speed and duplex > settings much match across the board too. > > If that doesn't bring them up for you, please paste your show run interface > results and maybe we can see what's going on for you. > > > Jason > > On Fri, May 9, 2008 at 9:09 AM, <irfanccie@hotmail.co.uk> wrote: > > >> it maybe the order of operations.. try configuring while interfaces are >> shut and then unshut.... >> >> also if you can send configs... >> >> -------------------------------------------------- >> From: "John" <jgarrison1@austin.rr.com> >> Sent: Friday, May 09, 2008 3:09 PM >> To: <ccielab@groupstudy.com> >> Subject: etherchannel >> >> >> I cannot get an etherchannel to come up with lacp or pagp. The channel >> >>> does >>> come up if I set the mode to on. With lacp and pagp I get pagp/lacp no >>> enabled on remote port. I'm setting both sides to active in lacp and >>> desirable with pagp. Anyone? >>> >>> >>> _______________________________________________________________________ >>> Subscription information may be found at: >>> http://www.groupstudy.com/list/CCIELab.html >>> >>> >> _______________________________________________________________________ >> Subscription information may be found at: >> http://www.groupstudy.com/list/CCIELab.html >> > > > _______________________________________________________________________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:16 ART