Re: Configuring MST

From: Sadiq Yakasai (sadiqtanko@gmail.com)
Date: Fri May 09 2008 - 09:01:25 ART

• Next message: Sadiq Yakasai: "Re: How I could stop the switch from learning the MAC"
• Previous message: ccie: "How I could stop the switch from learning the MAC address-table"
• Maybe in reply to: ccie: "Configuring MST"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Amin,

Two or more switches in the same MST region need to have the same
name, revision number and VLAN to Instance mapping. If you dont
configure any, the default values are used. So to answer your
question, your can optionally configure those, but if you dont, the
default values are used. See more below:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_25_see/configuration/guide/swmstp.html#wp1017196

Best way is always to lab it up and see :), if possible, feed us back pls.

HTH

Sadiq

• Next message: Sadiq Yakasai: "Re: How I could stop the switch from learning the MAC"
• Previous message: ccie: "How I could stop the switch from learning the MAC address-table"
• Maybe in reply to: ccie: "Configuring MST"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:16 ART