From: Simon simon (cisco-engineer@hotmail.com)
Date: Thu May 01 2008 - 14:31:21 ART
How to configure the following? 1)other AS may be directly connected to AS100.configure r1 to accept bgp routes from backbone 1 that originate only in AS 100 and may other AS directly connected to AS100. all other BGP routes should be filtered . use a filter list with only 1 regular expression to accomplish this.
2)Configure so that TELNET may be possible from R3, R4, SW1, SW2 to loopback 1 of R2 (155.4.13.1/24) , available in one router for this All traffics that occur in loop (155.4.13.1/24) must become block, not include telnet traffic enter only Telnet connection for a maximum of 30 second, after 30 second, the connection should be close and all of telnet connection should be audit 3)R1 & R3 are connected via F/R.configure ipv6 on both routers but the Ipv6 traffic doesnt traverse the frame-relay interfaces.configure ripng between these 2 routers Thanks a lot for ur help
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:15 ART