From: Brian Dennis (bdennis@internetworkexpert.com)
Date: Mon Apr 28 2008 - 17:17:57 ART
What terminal emulation software are you using? If you have using
SecureCRT you can adjust the "line send delay" or "character send delay"
under Global Options -> Advanced.
If you are using HyperTerm they are under File->Properties->Settings (Tab)
-> Ascii Setup (Button).
HTH,
Brian Dennis, CCIE4 #2210 (R&S/ISP-Dial/Security/SP)
bdennis@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: +1-775-544-1653 (Outside the US and Canada)
>----- Original Message -----
Subject: Pasting a config to the console
Date: Mon, April 28, 2008 12:33
From: "Botha Michael" <Michael.Botha@gmsa.com>
> I am sure everyone has encountered this before.
>
> When pasting a large config from the clipboard to the console line you
> run into buffer problems and only some of the config goes in.
>
> I was wondering whether anyone out there might have a geek nob to
> prevent/fix this from happening and having to stick the config in bit by
> bit.
> I know the config can be copied with TFTP,FTP etc but this is not the
> answer that I am looking for.
>
> TIA
>
>
> Pass the CCIE in six weeks, Guaranteed!
> http://www.certscience.com/CCIE
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Pass the CCIE in six weeks, Guaranteed!
http://www.certscience.com/CCIE
This archive was generated by hypermail 2.1.4 : Thu May 01 2008 - 08:25:52 ART