From: Roger (rpf@bluemail.ch)
Date: Tue Apr 22 2008 - 16:48:07 ART
Hi Group,
I have two QoS question:
1) On a 2821 with IOS124-18 when I try to apply a policy-map out on the
Gigabit Ethernet Interface I always get the following errormessage, even if
I reserve only a total of 75% (class high 35%, medium 30%, low 10%)
I/f GigabitEthernet0/1 class high requested bandwidth 35%, available only 5%
It must somehow be box related, because on a 2611XM the same config works
fine.
-->> Any Ideas?
2) On a C3550 following setup --R1--C3550--R2-- I configure a policer for
the class default and apply it to a FE Port. Than I ping from R1 to R2,
which should match my class default. I never see matches on the class
default with sh policy-map interface.
Is it not possible to only use the class default? Here my config:
!
policy-map CCIEpolicy
class class-default
police 1000000 187500 exceed-action drop
!
int fa0/4
service-policy input vlan11policy
!
Thanks
Roger
Pass the CCIE in six weeks, Guaranteed!
http://www.certscience.com/CCIE
This archive was generated by hypermail 2.1.4 : Thu May 01 2008 - 08:25:51 ART