From: Cockcroft, Lance (lc3881@att.com)
Date: Tue Apr 22 2008 - 10:33:47 ART
Are you using 3550, 3560, or Dynamips?
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
KS Anpu
Sent: Wednesday, April 16, 2008 1:21 AM
To: Cisco certification; anpu samp
Subject: Fwd: basic VTP issue ...
Yesterday i sent this mail. but i didnot get it in to my inbox , So i
am forwarding this mail again.
Regards,
Anbu.
---------- Forwarded message ----------
From: KS Anpu <ksanpu@gmail.com>
Date: Tue, Apr 15, 2008 at 10:32 PM
Subject: basic VTP issue ...
To: Cisco certification <ccielab@groupstudy.com>
SW3
/
/
/
SW1------SW2
\
\
\
SW4
I have tried to configure the above setup using the following senario.
SW1 is VTP Server
SW2,SW3,SW4 are VTP Clients
All are in same VTP domain
SW1 --- SW2 is trunk link (Port Channel)
SW2 --- SW3 is trunk link
sw2 --- SW4 is trunk link
Then i have created some vlans in SW1 but those vlans came to SW2 but
not came to SW3 and SW4.
So i have created some other VLANs in SW1 and increase the
configuration revision number and observe the other switches , SW2 got
the new vlans but still SW3 & SW4 are not getting any vlans.
then
i have tried to shutdown the SW2 - SW3 , SW3 - SW4 trunk links and
used no shutdown to refresh the trunk but no use.
so finally i have made trunklinks temporarly from SW1 to SW3 and SW1
to SW4 . after that all vlans are delivered to SW3 and SW4 then i
removed the temporarly trunk links and saved the configuration and
restarted all the switches.
Now the vlans are there in SW3 and SW4 eventhough it is not working
properly..
So i am expecting your Advise ,if i face an issue like this in my real
lab , what i want to do to troubleshoot.
Regards,
Anbu.
Pass the CCIE in six weeks, Guaranteed!
http://www.certscience.com/CCIE
This archive was generated by hypermail 2.1.4 : Thu May 01 2008 - 08:25:51 ART