From: Gupta, Gopal (NWCC) (gopal.gupta@hp.com)
Date: Thu Apr 10 2008 - 11:00:03 ART
Hi Asif,
Please ignore my previous post; I agree with Shine's answer.
Thanks
Gops
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Shine Joseph
Sent: Thursday, April 10, 2008 18:48
To: 'Asif'; 'Cisco certification'
Subject: RE: Access-list
Importance: Low
I don't think you can use a single line access-list to match the requirement
without overlapping addresses.
The best I can come up with is:
192.168.5.0 0.0.8.0
192.168.6.0 0.0.0.0
192.168.12.0 0.0.0.0
192.168.15.0 0.0.0.0
If you need to have single line ACL, the requirement would be different.
Please double check it is correct.
Regards,
Shine
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Asif
Sent: Thursday, 10 April 2008 10:20 PM
To: Cisco certification
Subject: Access-list
Hi,
on my MPLS Router I am getting couple of routes i.e ( 192.168.1.0/24-
192.168.14.0/24) and 10.10.1.0/24 - 10.10.5.0/24
I would like to see only the following routes in the routing table [
192.168.6.0/24 ; 192.168.5.0/24 ; 192.168.12.0 ; 192.168.13.0 ;
192.168.15.0 ]
how could the access-list look like as per my requirement.
Access-list 5 permit ip 192.168.0.0 X.X.X.x
Pass the CCIE in six weeks, Guaranteed!
http://www.certscience.com/CCIE
This archive was generated by hypermail 2.1.4 : Thu May 01 2008 - 08:25:50 ART