From: Enrique Langmaack (langmaack@gmail.com)
Date: Tue Apr 01 2008 - 18:57:22 ART
Hi guys,
Recently I was trying to do one of the internetwork expert sections in which
nat on a stick should be configured.
The solution includes a policy based routing in which traffic coming from an
specific network should be routed to a loopback which has an ip nat inside
statement. In order to forward the traffic to the interface they use a
route-map:
route-map NAT permit 10
match <match an access list>
set interface loopback 0
However, when I try to set the interface command, the router displays a
message that says something like the set interface command should only be
applied to non broadcast interfaces. (I don't remember the exact wording)
Unfortunally I don't know what IOS version I was using because it was a
racktimerentals session and I didn't write the version down.
Could someone tell me if this is a bug? Or could it be the IOS version?
Thank you guys,
Enrique
This archive was generated by hypermail 2.1.4 : Thu May 01 2008 - 08:25:49 ART