From: jaral18@hotmail.com
Date: Fri Mar 28 2008 - 19:29:03 ART
Hi,
I have a question about the "distance" command under EIGRP configuration
mode.
I need to change the administrative distance (to 172) of some routes learning
by EIGRP, and I'm using the distance command, but the result isn't the
expected, the routes have the default external administrative distance of
EIGRP (170) and not the 172 (the desired). I'm sure that I'm wrong in
something but I don't found it.
The comfiguration of the router is follows:
router eigrp 100 distance 172 0.0.0.0 255.255.255.255 from_RIP_R5!ip
access-list standard from_RIP_R5 permit 205.90.31.0 permit 136.1.7.0 permit
150.1.7.0 permit 136.1.57.0 permit 222.22.2.0 permit 220.20.3.0 permit
192.10.1.0
The "show ip route" of one route (the other routes have the same
administrative distance):
Rack1R2#sh ip route 136.1.7.1 Routing entry for
136.1.7.0/24 Known via "eigrp 100", distance 170, metric 3097600, type
external Redistributing via eigrp 100, ospf 1 Advertised by ospf 1 subnets
route-map change_path Last update from 136.1.23.3 on Serial0/1, 00:25:04 ago
Routing Descriptor Blocks: * 136.1.23.3, from 136.1.23.3, 00:25:04 ago, via
Serial0/1 Route metric is 3097600, traffic share count is 1 Total
delay is 21000 microseconds, minimum bandwidth is 1000 Kbit Reliability
255/255, minimum MTU 1500 bytes Loading 1/255, Hops 2
Thanks a lot and best regards
--------------------
Jose A. Arnau
--------------------
This archive was generated by hypermail 2.1.4 : Tue Apr 01 2008 - 07:53:54 ART