From: GS@infosecureltd.com
Date: Fri Mar 21 2008 - 14:47:31 ART
Hi
Etherchannel will take care of the load balancing over the multiple links.
It will also take care of the redundancy as it will just remove and links
that have failed from the channel.
Please see below for details:
http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/1
2.2_25_see/configuration/guide/swethchl.html
Regards, EP
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
mamadou thiam
Sent: 21 March 2008 10:01
To: Hash!!!
Cc: Timothy Chin; Shine Joseph; nagendra kumar; Z Linux;
ccielab@groupstudy.com
Subject: Re: Switching Question
it means that you must configure:
* dot1q trunk beetwen the switches
* and etherchannel
for exemple in switche n01
conf t
int range fast 0/19 - 20
switchport trunk encapsulation dot1q
switchport mode trunk
channel group 1 mode on
regards!
2008/3/21, Hash!!! <hashng@gmail.com>:
>
> I see a load-balance there any comments??
>
> ~#
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
> Of
>
> Timothy Chin
> Sent: Friday, March 21, 2008 9:43 AM
> To: Shine Joseph; nagendra kumar; Z Linux; ccielab@groupstudy.com
> Subject: RE: Switching Question
>
> I think it would be dot1q since isl encapsulates frames increasing
> overhead.
>
> Tim
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
> Of Shine Joseph
> Sent: Friday, March 21, 2008 1:30 AM
> To: 'nagendra kumar'; 'Z Linux'; ccielab@groupstudy.com
> Subject: RE: Switching Question
>
> I agree with dot1 q encapsulated ether-channel.
>
> But, wondering if you need to tag the native vlan as well? Any takers?
>
> Regards,
> Shine
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
> Of nagendra kumar
> Sent: Friday, 21 March 2008 12:45 PM
> To: Z Linux; ccielab@groupstudy.com
> Subject: Re: Switching Question
>
> Hope itz Layer 2 Etherchannel with LACP protocol and 802.1q trunking
> encapsulation.
>
> Regards,
> Nagendra
>
> Z Linux <z.linux@hotmail.com> wrote: Hi All,
>
> Can someone help with correct answer to the following Question :-
>
>
>
> All the 4 switches are connected to the 3 other switchesConfigure an
> IEEE protocol on all these inter-switches links so as to pass all the
> vlans.
> This includes the configuration of an IEEE Protocol that provies
> increasebandwidth and efficient utilization of the links and make sure
> fault-toleranceand load-balance.
>
> _________________________________________________________________
> Post free property ads on Yello Classifieds now! www.yello.in
> http://ss1.richmedia.in/recurl.asp?pid=221
>
> ______________________________________________________________________
> _ Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
> ---------------------------------
> Be a better friend, newshound, and know-it-all with Yahoo! Mobile.
> Try it now.
>
> ______________________________________________________________________
> _ Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> ______________________________________________________________________
> _ Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> ______________________________________________________________________
> _ Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> ______________________________________________________________________
> _ Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Apr 01 2008 - 07:53:54 ART