From: John (jgarrison1@austin.rr.com)
Date: Mon Feb 25 2008 - 20:59:54 ARST
It was on a rental rack. From now on I'll do a show controllers. I guess
I've just been lucky(50/50) configuring my hdlc connections up until today
----- Original Message -----
From: "Tony Schaffran (GS)" <groupstudy@cconlinelabs.com>
To: "'John'" <jgarrison1@austin.rr.com>; <ccielab@groupstudy.com>
Sent: Monday, February 25, 2008 4:19 PM
Subject: RE: hdlc clock rate
> It depends which side is the DCE.
>
> If you are using a back-to-back cable, the DCE is usually noted on one
> connector or the other.
>
>
> Tony Schaffran
> Network Analyst
> CCIE #11071
> CCNP, CCNA, CCDA,
> NNCDS, NNCSS, CNE, MCSE
>
> www.cconlinelabs.com
> Your #1 choice for online Cisco rack rentals.
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> John
> Sent: Monday, February 25, 2008 1:37 PM
> To: ccielab@groupstudy.com
> Subject: hdlc clock rate
>
> I've got 2 routers R2 and R3 that I'm supposed to connect with hdlc. I
> ran
> into a problem I've never seen before. When I apply the clock rate
> command
> on
> R2 the circut wouldn't come up. I then do a no clock rate on R2 and apply
> it
> on R3 the circut comes up. I have stac compression enabled on the
> interfaces.
> I don't know if that makes a difference.
>
> I didn't think it mattered which end I applied the clock rate command to.
> If
> someone can shine a light on this issue I would greatly appreciate it.
>
> JG
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2008 - 16:54:49 ARST