From: Carlos Trujillo Jimenez (nergal888@hotmail.com)
Date: Mon Feb 04 2008 - 11:55:44 ARST
Try doing the same as cciehksg is telling, but before that shutdown at both
sides the physical interfaces who belong to the same bundle, then configure
both sides exactly the same.. then compre both sides again.. and finally
activate (no shut) the physical links.. try also doing a debug etherchanell
event, error and detail.
cheers.
> Date: Mon, 4 Feb 2008 17:23:06 +0800> From: cciehksg@yahoo.com.sg> Subject:
Re: Port-Channels not coming on> To: ysoyibo@hotmail.com;
ccielab@groupstudy.com> > try configure both side simultanously> i mean enter
the command at the same time on both side> and share your config here> >
ysoyibo@hotmail.com wrote:> I have set up my port channels and they are not
coming up. I have made sure that the interface setting are the same of all
interfaces. Also 'channel-group X mode on' is congfigured on all. I see
err-disable on the interfaces and the port channels not coming on.> > How can
I start to troubleshoot this problem and eventually what is(are) the probable
causes of this keeping in mind what has been said earlier.> > Rgds> > Yemi> >
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2008 - 16:54:47 ARST