From: Cielieska Nathan (ncielieska@gmail.com)
Date: Tue Jan 22 2008 - 21:20:54 ARST
possibly sdm?
use the sdm vlan option
On Jan 22, 2008, at 6:28 AM, Amr CCIE wrote:
> Dear All,
> I have a problem with one of my switches (Cisco 2950) when
> adding a new vlan on it
> The following message appears when configuring new vlan
>
> *POP-switch#conf t*
> Enter configuration commands, one per line. End with CNTL/Z.
> *POP-switch(config)#vlan 71*
> POP-switch(config-vlan)#^Z
> Proposed configuration has too many VLANs for this device's core
> memory
> resources. Either reduce the number of VLANs proposed or use
> another VTP
> device to configure database. (The latter will cause this device
> to enter
> TRANSPARENT mode automatically if propagated to it.)
> APPLY VLAN changes failed.
>
>
> *POP-switch#sh vlan id 71
> *VLAN id 71 not found in current VLAN database
>
> Show memory gives that the Switch has a fee memory
>
> *POP-switch#sh memory*
> Head Total(b) Used(b) Free
> (b)
> Lowest(b) Largest(b)
> Processor 80BA6420 4803552 2315660 2487892 2359716
> 2444004
> I/O A08C16E0 3034400 689092 2345308
> 2305068 2344440
>
>
> I have only 65 active vlans on the switch
> I tried to add the vlan using the vlan database but the same
> message appears
> too
>
> I am using the following IOS image "*c2950-i6q4l2-mz.
> 121-19.EA1c.bin*"
>
> Any help on this behavior
>
> Regards
>
> ______________________________________________________________________
> _
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:38:00 ARST