From: keith tokash (ktokash@hotmail.com)
Date: Mon Jan 21 2008 - 20:35:16 ARST
You can also use summarization, depending on the scenario. I prefer that to
AD due to the very low likelihood that you will unintentionally jack up some
other part of your network from 2 sections before.
With a few exceptions, secrecy is deeply incompatible with democracy and with
science.
--Carl Sagan
> Date: Sun, 20 Jan 2008 19:04:31 -0200
> From: danielfrvalle@gmail.com
> To: nhatphuc@gmail.com
> Subject: Re: Change metric-type violate rule: "don't change metric"?
> CC: mohamedouamer@hotmail.com; ccielab@groupstudy.com
>
> Hi ,
>
> If the question says to not touch the metric... I would not touch the
> metric nor the metric-type.
>
> besides, if you change the metric-type to E1, you are indeed changin
> the metric all the way through the OSPF domain.
>
> I agree to use distance on every device in the ospf domain and stating
> that from the source R1, use the acl (Routes redistributed from eigrp)
> and then set a lower AD.
>
> Another good advice is to ask the proctor if you can use it or not.
>
>
>
> On Jan 19, 2008 5:12 PM, nhatphuc <nhatphuc@gmail.com> wrote:
> > Thanks for you interest.
> >
> > You meant only distance command works?
> >
> > metric-type will violate the requirement?
> >
> > Phuc
> >
> > On Jan 20, 2008 1:43 AM, mohamed ouamer <mohamedouamer@hotmail.com>
wrote:
> >
> > > Use the distance command.
> > >
> > > > Date: Sat, 19 Jan 2008 02:38:21 +0700
> > > > From: nhatphuc@gmail.com
> > > > To: ccielab@groupstudy.com
> > > > Subject: Change metric-type violate rule: "don't change metric"?
> > >
> > > >
> > > > Hi Group,
> > > >
> > > > I have a scenario in which OSPF and EIGRP are redistributed mutually
on
> > > R1
> > > > and R2
> > > >
> > > > The requirement:
> > > >
> > > > - configure the network so routers in OSPF prefer R1 over R2 to reach
> > > > Network A.
> > > > - Do not change the metric of routes redistributed from EIGRP into
OSPF
> > > on
> > > > either R1 or R2 to accomplish this.
> > > >
> > > > Will it violate the task If I change the metric type of routes
> > > redistributed
> > > > from EIGRP -> OSPF on R1 to E1?
> > > >
> > > > Thanks
> > > >
> > > > Phuc
> > > >
> > > >
This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:38:00 ARST