RE: multipoint subinterfaces refused

From: Gopalan Rajkumar (gopalan.rajkumar@emirates.com)
Date: Mon Jan 21 2008 - 08:36:01 ARST

• Next message: Gopalan Rajkumar: "RE: Broadcast Usage in Frame Relay"
• Previous message: shiran guez: "Re: multipoint subinterfaces refused"
• Maybe in reply to: Navid Daghighi: "multipoint subinterfaces refused"
• Next in thread: Gary Duncanson: "Re: multipoint subinterfaces refused"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Navid,

Enable frame relay encapsulation (command: encapsulation
frame-relay).Then you will get the option of creating a point-to-point
ot multipoint sub interface

Regards,
Gopalan Rajkumar
Emirates Group IT
Phone : +971-4-2185161

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Navid Daghighi
Sent: 21 January 2008 14:14
To: Cisco certification
Subject: multipoint subinterfaces refused

Hi,

on my routers, when I type "interface s0.X multipoint", the IOS refuses
with "invalid input at ^multipoint"
whatever being X
while int s0.X point is accepted

I run IOS 12.3(15)

any idea where is this coming from ?

thanks,
Navid

• Next message: Gopalan Rajkumar: "RE: Broadcast Usage in Frame Relay"
• Previous message: shiran guez: "Re: multipoint subinterfaces refused"
• Maybe in reply to: Navid Daghighi: "multipoint subinterfaces refused"
• Next in thread: Gary Duncanson: "Re: multipoint subinterfaces refused"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:38:00 ARST