From: Sohail Nedaria (sohail.nedaria@gmail.com)
Date: Thu Jan 17 2008 - 03:39:37 ARST
Hi mick
Broadcast Keyword should apply only on link Local address because
that address will be ur next-hop address once u will see in ur show ipv6
route table.Correct me if i am wrong.
Thanks
Suhail.
On Jan 15, 2008 5:55 AM, Mick Vaites <mick@pobox.net.uk> wrote:
> Hi all,
>
> I am puzzling over which is correct and which is not.
>
> It is necessary to put in L2 / L3 mappings for both the actual IPv6
> addressing as well as the lnik local addresses but which gets the
> broadcast statement?
>
> Senario: two routers connected for IPv6, R1 and R5 over a frame-relay
> cloud, network is 2001:cc1e:5:15::x/64 and the DLCI's are 105 and 501
> respectively. This are the possible snippets for R1. (apologies for any
> obvious typos).
>
> I am wondering which is right
>
> !R1
> Interface Serial 1/0
> ipv6 address 2001:cc1e:5:15::1/64
> ipv6 address fe80::1 link-local
> frame-relay map ipv6 fe80::5 105 broadcast <---- broadcast on the
> link-local
> frame-relay map ipv6 2001:cc1e:5:15::5 105
>
> or
>
> !R1
> Interface Serial 1/0
> ipv6 address 2001:cc1e:5:15::1/64
> ipv6 address fe80::1 link-local
> frame-relay map ipv6 fe80::5 105
> frame-relay map ipv6 2001:cc1e:5:15::5 105 broadcast <----- broadcast
> on the main IP
>
> I have tried both of these senarios and both work okay ?
>
> Best regards
>
> Mick
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Thanks And Regards Suhail.U.Nedaria 9833256425 CCIE# 19337.
This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:38:00 ARST