From: Beau Hahn (bhahn1986@gmail.com)
Date: Sat Jan 12 2008 - 23:17:20 ARST
Multiaccess interfaces require a next-hop in the route-map. This is a loop
prevention mechanism. To use the interface would cause duplication of
packets and possible re-injection and further duplication as all routers on
the segment would receive it.
On Jan 11, 2008 7:19 AM, Todd, Douglas M. <DTODD@partners.org> wrote:
> Hello:
>
> Seems like the interface is not a point to point interface (could be a
> bogus
> error message)
> Even if you could tie the interface to the route map you could not tie the
> route
> map to the rip process. Because of this using a route map for generation
> of a
> default route in rip is not possible (at least from my point of view).
>
> The only possible options are as follows for getting a default route into
> rip:
>
> *The ip default-network command is configured.
> *The default-information originate command is configured.
> *The default route is learned via another routing protocol or static route
> and
> then redistributed into RIP.
>
> -Mac
>
>
>
> -----Original Message-----
> From: nobody@groupstudy.com on behalf of seyfert22@googlemail.com
> Sent: Thu 1/10/2008 3:16 AM
> To: ccielab@groupstudy.com
> Subject: Cannot set interface for route manipulation in Route-map
>
> I want to generate a default route in Rip ,just for particular interface
> (e0/1).
> I know,that I can use distribute-list for this .
> But I hear that I can use "set int" for this..
>
>
> router rip
> default-info originate route-map DEFAULT
>
> R4(config)#route-map DEFAULT permit 10
> R4(config-route-map)#set int e0/1
> % route-map:can not set interface.
> % Use P2P interfaces for set interface clause
>
>
> any sollution for this?
>
> thanks be4
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> The information transmitted in this electronic communication is intended
> only
> for the person or entity to whom it is addressed and may contain
> confidential
> and/or privileged material. Any review, retransmission, dissemination or
> other
> use of or taking of any action in reliance upon this information by
> persons or
> entities other than the intended recipient is prohibited. If you received
> this
> information in error, please contact the Compliance HelpLine at
> 800-856-1983 and
> properly dispose of this information.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Beau HahnCompTIA A+ Certified, IT Technician Cisco Certified Network Professional Zend Certified Engineer, PHP 5
This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:37:59 ARST