Switch port-security

From: Gupta, Gopal (NWCC) (gopal.gupta@hp.com)
Date: Sat Jan 12 2008 - 15:39:01 ARST

• Next message: cisco-engineer@hotmail.com: "According to CCIEcert Workbook"
• Previous message: Gupta, Gopal (NWCC): "RE: OSPF Neighbor Command Issue"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Experts,

Is it possible using switch port-security to limit the user to connect
only phone to some port and not any PC on that port ???
If yes ,please let me know how ???

I tried to do as following:

interface FastEthernet0/18
 switchport mode access
 switchport voice vlan 51
 switchport port-security
 switchport port-security violation shutdown switchport port-security
maximum 1 vlan voice spanning-tree portfast end

but it is still learning the Mac address on this port from Vlan 1
(Default Vlan for access port)

SW4#sh port-security int f0/18
Port Security : Enabled
Port Status : Secure-up
Violation Mode : Shutdown
Aging Time : 0 mins
Aging Type : Absolute
SecureStatic Address Aging : Disabled
Maximum MAC Addresses : 1
Total MAC Addresses : 1
Configured MAC Addresses : 0
Sticky MAC Addresses : 1
Last Source Address:Vlan : 0019.2f90.860d:1
Security Violation Count : 0
S
I just wanted this port to learn Mac addresses for only voice phone and
not Data.
Is this possible to only secure mac for voice phone??

Thanks,
Gops

• Next message: cisco-engineer@hotmail.com: "According to CCIEcert Workbook"
• Previous message: Gupta, Gopal (NWCC): "RE: OSPF Neighbor Command Issue"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:37:59 ARST