RE: changing a subint type

From: Lars L. Christensen (lars@perseus.dk)
Date: Fri Jan 11 2008 - 17:57:36 ARST

• Next message: m hussain: "test plz ignore"
• Previous message: m hussain: "Jan 18 (RS lab) need to swap....(Brussels)"
• Maybe in reply to: Navid Daghighi: "changing a subint type"
• Next in thread: Shine Joseph: "RE: changing a subint type"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Delete the subinterface and reboot. Then you can reconfigure the
subinterface.

Cheers,
Lars Lystrup Christensen

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Navid Daghighi
Sent: 10. januar 2008 11:49
To: Cisco certification
Subject: changing a subint type

Hi,

I typed "interface s0/0.1 multi-point"

I need to change this into "point-to-point"

when i do "no int s0/0.1" and "int s0/0.1 point", it keeps the subtype
and refuse to change the link type

what is the solution ?

thanks,
Navid

• Next message: m hussain: "test plz ignore"
• Previous message: m hussain: "Jan 18 (RS lab) need to swap....(Brussels)"
• Maybe in reply to: Navid Daghighi: "changing a subint type"
• Next in thread: Shine Joseph: "RE: changing a subint type"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:37:59 ARST