TCP load distribution using NAT

From: CCIE (ccie@axizo.com)
Date: Fri Jan 11 2008 - 10:12:38 ARST

• Next message: Todd, Douglas M.: "RE: Cannot set interface for route manipulation in Route-map"
• Previous message: Salau, Yemi: "RE: 'Narbik Kocharians bootcamp feedbak ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello dear,

I have just configured TCP load distribution using NAT, and I am sure
everything is 100% correct, but once I pass traffic from the outside to the
inside then check the show ip nat translation, I discover no translation
available at all. Any body has an idea if checking the translation is
through this command or through another command?

Regards,

Amin

• Next message: Todd, Douglas M.: "RE: Cannot set interface for route manipulation in Route-map"
• Previous message: Salau, Yemi: "RE: 'Narbik Kocharians bootcamp feedbak ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:37:59 ARST