From: Scott Vermillion (scott_ccie_list@it-ag.com)
Date: Wed Jan 09 2008 - 02:25:39 ARST
Hey again Navid,
Just had a quick gander at that lab topology. IIRC, this was somewhat of a
contrived situation that gives you the need to configure a certain feature
of BGP (accept your own AS in BGP advertisements). You won't see that too
often (at least not through Lab 11 you won't, which is as far as I can speak
authoritatively)...
Regards,
Scott
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Navid Daghighi
Sent: Tuesday, January 08, 2008 1:19 PM
To: Cisco certification
Subject: iBGP full mesh impossible ?
Hi,
I understand we should always try to use either route-reflectors or
confederations when we don't have a full mesh iBGP
but some times it IS impossible, as in IE R&S lab 3, where there are 2
totally disjointed groups of routers in the same AS
is there any other situation where we should not loose time trying to
fullfil this iBGP full mesh requirement ?
thanks,
Navid
This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:37:58 ARST