From: Godswill Oletu (oletu@inbox.lv)
Date: Wed Dec 26 2007 - 22:39:39 ART
Hi Mark,
It is not work out; I applied the CSS to the H323 gateway, also to the
device and also to the DN.
The CallManager DN & the route pattern have the same partition. I also reset
the gateway after, but no luck.
Godswill Oletu
CCIE #16464 (R&S)
----- Original Message -----
From: "Mark Snow" <msnow@ipexpert.com>
To: "Godswill Oletu" <oletu@inbox.lv>
Cc: "Cisco certification" <ccielab@groupstudy.com>
Sent: Wednesday, December 26, 2007 8:04 PM
Subject: Re: CME Phone Calling CallManager DN with Partition?
> On your H323 GW page you need to change the Calling Search Space for
> inbound calls to something that contains the Partition of 6xxx.
>
> Change that and report back.
>
> Mark Snow
> Sr Technical Instructor
> IPexpert, Inc.
>
> Sent from my iPhone
>
> On Dec 26, 2007, at 5:49 PM, Godswill Oletu <oletu@inbox.lv> wrote:
>
>> I have been battling with this for sometime now.
>>
>> My CME gateway is registed with the CallManager via H323, the dial
>> pattern on the CallManager pointing to the CME gateway is using a route
>> list, then a route group that contain the CME gateway.
>>
>> I have a CallManager DN of e.g. 6001, in a partition call 6xxx; the dial
>> pattern pointing to the the CME gateway also have the partition of 6xxx.
>>
>> Results:
>> With the partition in DN 6001; Ph 6001 can call CME phone, but CME phone
>> cannot call callmanager ph 6001.
>>
>> Without partition in DN 6001; everything works fine.
>>
>> are mine missing anything here?
>>
>> Godswill Oletu
>> CCIE #16464 (R&S)
>>
>> _______________________________________________________________________
>
>
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jan 01 2008 - 12:04:32 ARST