From: Hash!!! (hashng@gmail.com)
Date: Wed Dec 26 2007 - 12:01:25 ART
Hi Chan,
The default Max-Age timer of Spanning tree is 20 seconds ..Defaults don't
show in the IOS.
Just my understanding of the Question I don't have the workbook .
HTH
Hash #16818
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Chan
Hong
Sent: Wednesday, December 26, 2007 12:42 PM
To: certification Cisco
Subject: IPExpert Lab 21
Dear all,
I want to ask some questions about IPExpert lab 21. Some of them
are not technical question but the way to understand what is the task
request
us to do.
1: In the switching part, it request us to change the spanning tree
age timer to 20. But I don't see any config relate to spanning-tree timer in
the final config. Is that "age timer" means max age in the result of "show
spanning-tree vlan xx"?
sw1#sh spanning-tree vlan 12
VLAN0012
Spanning tree
enabled protocol ieee
Root ID Priority 32768
Address
0001.426d.2141
Cost 19
Port 24
(FastEthernet0/24)
Hello Time 2 sec Max Age 20 sec Forward
Delay 15 sec
Bridge ID Priority 32780 (priority 32768 sys-id-ext 12)
Address 000a.4186.a680
Hello Time 2 sec Max Age 20 sec
Forward Delay 15 sec
Aging Time 300
Interface Role Sts
Cost Prio.Nbr Type
---------------- ---- --- --------- --------
--------------------------------
Fa0/24 Root FWD 19 128.24
P2p
sw1#
2: What is the meaning of "add loopbacks as deemed necessary"?? I
just put the loopback into routing process. Is that the task request to put
the loopback subnet as external route?
3: in the BGP part, it use "neighbor
x.x.x. local-as" to make R4,5,6 look ask AS600 in R7. But I don't think it
will work for the R2, which under AS610.
Regards,
Howard
_______________________________________
YM - i"g7h(
f/
e01g.d= f2f d8
g62o<
d= gf
e
d;
e/d;%gd8
h(
f/g5&d= o<
g6d= d8
g6
2fe01h=g+
e
3g
e0o<
d;;d=h**h)1i=e
h50e$1c
http://messenger.yahoo.com.hk
This archive was generated by hypermail 2.1.4 : Tue Jan 01 2008 - 12:04:32 ARST