From: Arun Kumar Arumuganainar (aarumuga@hotmail.com)
Date: Thu Dec 13 2007 - 11:16:40 ART
oops sorry I found the answers
distance 150 <ip address > <inverse mask >
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hirp_r/
rte_pih.htm#wp1134155
Earlier I was looking 12.1 command reference. That was the reason I did not
find this command,
Thanks and Regards
Arun
> Subject: RE: Configuring Distance Per Neighbor> Date: Thu, 13 Dec 2007
11:36:15 +0000> From: subodh.rawat@wipro.com> To: aarumuga@hotmail.com> CC:
ccielab@groupstudy.com> > One way is there however:> > You can redistribute
routes at R1. This will cause all routes to become> as External EIGRP routes
and hence will carry an AD of 170. and routes> learned from R3 will carry
default AD of 90.> > HTH> Subodh > > -----Original Message-----> From: Subodh
Singh Rawat (WT01 - TELECOM SERVICE PROVIDER) > Sent: Thursday, December 13,
2007 4:55 PM> To: 'Arun Kumar Arumuganainar'> Cc: Cisco certification>
Subject: RE: Configuring Distance Per Neighbor> > Can be done with offset
list.> > Distance has no effect on same routing protolcs (EIGRP in this
case).> > HTH> Subodh > > -----Original Message-----> From:
nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of> Arun Kumar
Arumuganainar> Sent: Thursday, December 13, 2007 4:25 PM> To: Radioactive
Frog; nhatphuc> Cc: Cisco certification> Subject: Configuring Distance Per
Neighbor> > Hi ,> > I have a problem.> > > R1 ----R2----R3> > The network is
running eigrp. I wanted to assign Higher admin distance> to all routes learned
from R1 and lower admin distance to all routes> learned from R3 .> >
Configuration needs to be done on R2.> > I know it can be done using inverse
mask and ACL . But could not figure> out how to do this.> > It will be very
helpful if some body let me know how to do it .> > Thanks and Regards> Arun>
This archive was generated by hypermail 2.1.4 : Tue Jan 01 2008 - 12:04:30 ARST