RE: LAB 25 RIP Configuration

From: Biggs, Jeff \(M/CIO/BIE\) (JBiggs@usaid.gov)
Date: Wed Dec 12 2007 - 11:40:09 ART

• Next message: keith tokash: "RE: OSPF Neighbour config wont stick in config ?"
• Previous message: Scott Morris: "RE: VLAN Access Maps for IP Traffic Filtering"
• Maybe in reply to: Biggs, Jeff \(M/CIO/BIE\): "LAB 25 RIP Configuration"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Gotcha.....

I realized it after I sent the email....DUHHHHH. My bad. Sometimes I
wish I had a 60 hold timer on my emails so I could kill them before they
go out.

Jeffrey Biggs

Sr. Network Engineer

USAID

M/CIO/BIE

240-646-5003

jbiggs@usaid.gov <mailto:jbiggs@usaid.gov>

From: Dragan Ilic [mailto:dragancili@gmail.com]
Sent: Wednesday, December 12, 2007 9:38 AM
To: Biggs, Jeff (M/CIO/BIE)
Subject: Re: LAB 25 RIP Configuration

It's a RIP calculated time...

So:

update timer

invalid timer = 3 x update

HTH,

DRAGAN

On Dec 12, 2007 3:26 PM, Biggs, Jeff (M/CIO/BIE) <JBiggs@usaid.gov>
wrote:

It is asked to set the rip update timer to 45 seconds and remove the
Holddown timer.

This is what I put:

timers basic 45 180 0 240

But the answer states this:

Timers basic 45 135 0 360

I understand that you should adjust "all" timers if you adjust one, but
where did "135" come from?

Jeffrey Biggs

Sr. Network Engineer

USAID

M/CIO/BIE

240-646-5003

jbiggs@usaid.gov <mailto:jbiggs@usaid.gov >

• Next message: keith tokash: "RE: OSPF Neighbour config wont stick in config ?"
• Previous message: Scott Morris: "RE: VLAN Access Maps for IP Traffic Filtering"
• Maybe in reply to: Biggs, Jeff \(M/CIO/BIE\): "LAB 25 RIP Configuration"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Jan 01 2008 - 12:04:30 ARST